SABINE NAV4802-DC-U Betriebsanleitung PDF herunterladen (Seite 21)

Navigator2_OperatingGuide110928.indd

Ethernet

You can set the parameters for Ethernet connections in this window. Each Navigator in a network

must have a unique IP address. This adjustment is also available in the Navigator Software. See

Section 6.7 of this guide for a complete explanation of creating a Navigator Network using standard

Ethernet connections.

• IP ADDRESS: Unique network address of the Navigator. Number above is a good place to start.

• GATEWAY ADR: Default address of a network. Set as shown above unless your network admin-

istrator recommends another setting.

• SUBNET MASK: Limits what the Navigator can see on the network. Set as shown above.

• Cycle Power When Finished.

I/O Mode

For units with the “D” option for Digital I/O, only available on NAV 4802 or 8802 units. Choose the

Input/Ouput type for each pair of inputs or outputs. A = Analog, and D = Digital.

• I12: A = Input pair 1 and 2, set to Analog, etc.

• O34: A = Output pair 3 and 4, set to Analog., etc.

Mic Preamp

For units with the “M” option for Mic Preamp. Choose either Mic level or Line level for each input.

This front-panel switching is only available on NAV4802 or 8802. NAV240 and 360 have back panel

switches for this function.

• 1: Mic = Input 1 set to Mic Level

• 2: Line = Input 2 set to Line Level, etc.

• P: On = Phantom Power turned on for all inputs

Se c t i o n fi V e : op e r a t i n g t h e na V i g a t o r

NAV4802 & NAV8802

NAV240, 360

Not available

NAV4802 & NAV8802

NAV240, 360

Not available - controlled with

back panel switches

NAV4802 & NAV8802

NAV240, 360

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Keine Kommentare

SABINE NAV4802-DC-U Betriebsanleitung Seite 21